The compression gas spring is filled with inert gas, which acts elastically through the piston. This product works without external power, lift is stable, can be retractable. (can lock the gas spring can be arbitrarily positioned) it is widely used, but the installation should pay attention to the following points:
1. The piston rod of the compression gas spring must be installed downward, not inverted, so as to reduce friction and ensure better shock absorption quality and buffering performance.
2. Determining the installation position of the fulcrum is the guarantee that the compression gas spring can work correctly, seriously and smoothly. The installation of the compression gas spring must be correct, that is, to move to the center line of the structure when closed, otherwise the compressed gas spring will often actively open the door.
3. Compression gas spring in the work should not be subjected to tilt force or lateral force. Shall not be used as handrails.
4. In order to ensure the stability of the seal, do not damage the piston rod surface, do not apply paint and chemicals on the piston rod. It is also not permitted to install the gas spring in the required position before spraying or painting.
5. The air spring is a high pressure product. It is forbidden to analyze, bake or crush at will.
6. The piston rod of the compression air spring is not allowed to turn to the left. If you need to adjust the orientation of the connector, you can only rotate it to the right.
7. Ambient temperature :-35℃-+70℃(80℃ for specific manufacturing).
8. Installation connection point, rotation should be flexible, should not be stuck.
9. The size can be selected reasonably, the strength can be appropriate, and the stroke size of the piston rod can leave a margin of 8mm.
When using the compression gas spring, if the Angle of the hydraulic lever is not right, according to the overall lever principle, in this process, the power arm is too short, which will directly lead to the inability to better play the force. So we couldn't get it off while we were using it. These aspects will have a great impact on the overall use, so be sure to keep abreast of the clear.
Sometimes the compression gas spring does not move at all, it is also possible that the hydraulic rod itself is damaged. Part of this is probably due to the mechanics themselves, so no matter how hard we try, we can't make it work. Therefore, we need to make corresponding checks in the process of use to see whether it is intact. If there's a problem, don't reinvent the wheel.
In the other case, the compression gas spring does not move. Maybe the guy with the lever is weak. In this process, the pressure is not the same, but in the process of use, the specific method is not the same. If you have too little force, sometimes you can't press it. Therefore, everyone should have a correct understanding. By correctly identifying the cause of the problem, we can be more secure in the process of solving the problem.
Post time: Oct-19-2022
