Several problems should be paid attention to when purchasing loackable gas spring:
1. Material: seamless steel pipe with wall thickness of 1.0mm.
2. Surface treatment: some pressures are black carbon steel, and some thin rods are electroplated and wiredrawn.
3. Pressure selection: The greater the pressure of the hydraulic rod, the better (too big to press, too small to support).
4. Length selection: the length of the pneumatic rod is not precise data, and it can also be used normally if the relative hole spacing is 490 or 480 (it can be used normally if the length error is within 3cm).
5. Joint selection: the two types of joints can be interchanged (A type head hole diameter is 10mm, F type head is wood screw hole 6mm).
Installation method of lockable gas spring:
The lockable gas spring has a great advantage that it is easy to install. Here we describe the common steps for installing the lockable gas spring:
1. The gas spring piston rod must be installed in a downward position, not upside down, so as to reduce friction and ensure good damping quality and cushioning performance.
2. Determining the installation position of the fulcrum is the guarantee for the correct operation of the gas spring. The gas spring must be installed in a correct way, that is, when it is closed, let it move over the middle line of the structure, otherwise, the gas spring will often push the door open automatically.
3. The gas spring shall not be subjected to tilt force or lateral force during operation. It shall not be used as handrail.
4. In order to ensure the reliability of the seal, the surface of the piston rod shall not be damaged, and paint and chemicals shall not be painted on the piston rod. It is also not allowed to install the gas spring at the required position before spraying and painting.
5. The gas spring is a high-pressure product, and it is strictly prohibited to dissect, bake or smash it at will.
Attention shall be paid during installation: to ensure the reliability of sealing, the piston rod surface shall not be damaged, and paint and chemicals shall not be painted on the piston rod. It is also not allowed to install the gas spring at the required position before spraying and painting. Remember that the piston rod must not rotate to the left. If it is necessary to adjust the direction of the connector, it can only be turned to the right. This also allows you to rotate in a fixed direction. The size of the gas spring should be reasonable, the force should be appropriate, and the stroke size of the piston rod should be spaced, so that it can not be locked, or it will be very troublesome to maintain in the future.
If you want to know more about lockable gas spring,please keep an eye on Guangzhou Tieying Gas Spring Technology Co.,Ltd.
Post time: Dec-05-2022
