In the process of using the compression gas spring, you may have some problems in the use. The following brief section summarizes some common problems, giving you examples, and the following are examples of related problems.
1. Do you need to use tools to compression gas spring?
The compression gas spring does not need tools for compression, so the answer to this question is "No". Moreover, we also need to know that the center distance in the compression gas spring is the installation length. Whether the length is appropriate or not is related to whether the gas spring can be directly installed. Therefore, we should pay attention to it and not take it lightly.
2. Which of the technical conditions and standards of the compression gas spring should be referred to? And whether its working principle is the same as that of ordinary gas spring?
The technical conditions and standards of compression gas spring mainly refer to GB 25751-2010. As for its working principle, it is the same as the ordinary gas spring. It realizes the movement of its internal piston rod through the pressure difference generated inside, so as to achieve the purpose of use.
3. Can the compression gas spring be used on the side compartment door of the bus?
The compression gas spring can be used on the side compartment door of the bus, so the answer to this question is yes. Moreover, if the compressed air spring is used, the repositioning of the side compartment door can be well completed to prevent it from being impacted, thus causing damage, even damage, and further affecting the service life. However, it should be noted that the compression degree of the compressed air spring is determined by the weight of the side compartment door and the pressure of the air spring.
The compression gas spring is also widely used. Some buses and cars also use compressed air springs. The safety of vehicles is important, so pay attention to the inspection of compression gas springs.
Post time: Jan-04-2023
